Is this carb to small to run on a 13B streetport? What size is this carb?

 

Hey gonzz, have the owner check the side of one of those barrels for the model number. That is how I figured out what size the set was that you sold to me. Alternately, the owner can take one of the velocity stacks off and use a set of calipers to take a measurement. On those 40's that I have, the opening up top was ~45mm but the Mikuni's taper and the number on the barrels said they were 40's. Hope this helps. Good luck with the project!

 

What are all the markings on the carb? You should see 40 PHH or something similar on it somewhere.

 

Almost forgot. Somewhere on this board someone said the Mikuni PHH 44 flows 211cfm per barrel. That should help since that would be 422cfm for a single carb. Compare that to other carbs made for a streetport 13b.

 

Gonzz, you'd get a lot more for it on ebay if you did your homework. The carb and manifold should each go for what you're getting.

http://cgi.ebay.com/ebaymotors/ws/eB...category=33550

 

That's not mine. I was thinking of getting it

 

Sorry, just figured since you're in Vegas too... Pick it up - it's a nice carb.