I have a 79 rx with the racing beat holly carb setup, but it is missing a linkage. I purchased it from someone on ebay and when I got it i noticed that it was missing the linkage that goes to the mitering oil pump rod. Does any one have a picture of this linkage (on or off the carb) that i could use as refrence when fabricating a new one? or perhapse someone has an extra for sale? please pm me, post or email me (kyrlenelson@yahoo.com).

-Kyrle

 

you mean its missing the rod or what? the piece on the holley is just a hole, not really a linkage. if its just the rod, bend up whatever you can find and place it in there, or just pre-mix and forget about it entirely.

g'luck

 

No not the rod. Apparantly there is a clip of some kind that connects between the rod and the carb arm.