I need a bit of a rear fender .
Thread Starter
Damn, it did start!
Joined: Feb 2001
Posts: 2,771
Likes: 470
From: washington
I need a bit of a rear fender .
this is off of the drivers side facing toward the rear, I have no digital camera so here it goes.
it is a strip of metal. best described as the flare on the rear (facing the end of the car) about 3-4 inches wide and about 16 inches from th start of the seam on the bottom of the car. It would be cut slightly above the top of the molding level. As I said on the drivers side. I really need this and ASAP. it also need to be free of rust of course
.
this is my most desperate hour; help me RX-7 Forum, You're my only hope.
it is a strip of metal. best described as the flare on the rear (facing the end of the car) about 3-4 inches wide and about 16 inches from th start of the seam on the bottom of the car. It would be cut slightly above the top of the molding level. As I said on the drivers side. I really need this and ASAP. it also need to be free of rust of course
. this is my most desperate hour; help me RX-7 Forum, You're my only hope.
Thread
Thread Starter
Forum
Replies
Last Post
MILOS7
3rd Generation Specific (1993-2002)
10
Aug 19, 2015 07:25 AM