Help Please . Ground Wire Q`s
#1
RX7mall
Thread Starter
Join Date: Sep 2003
Location: ft lauderdale
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
Help Please . Ground Wire Q`s
I..have a pair of cobra eye`s . Yes I know not everyone likes them.. But One is not working. I followed the Wires back and found, what I think is the ground wire not attached to anything. From the photos, Can I attach wire to nut in photo?
If yes, If I loosen bolt to place wire under it will it tighten back up? or do I need to go behind panel and hold a bolt from the back side.
Thanks is advance for any help
If yes, If I loosen bolt to place wire under it will it tighten back up? or do I need to go behind panel and hold a bolt from the back side.
Thanks is advance for any help
#2
Rotary Enthusiast
Join Date: Dec 2004
Location: Campbell, CA
Posts: 1,025
Likes: 0
Received 0 Likes
on
0 Posts
yes, that nut will tighten back up. As for the wire, you should get a electrical terminal on there before doing that. Did you install them your self? or who did the work, they should really all have been on electrical connectors. Go to the radio shack and show them what you have. Also, just to make sure it's ground, are you sure you have followed that wire correctly? does the other wire go to the switch?
#3
RX7mall
Thread Starter
Join Date: Sep 2003
Location: ft lauderdale
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
"..electrical terminal .." Not sure what that is, I had pep-boys install them after i had purchased them .. I have had them over a year, so iwill go back and ask if they can fix.. or add the "..electrical terminal .." as you suggest .. thanks for the reply with the info..
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM