Going to have to pull wires to a new pump relay, since they appear to have been removed during a dash swap. I pulled my Haynes (#460), and turned to page 302.

So far, I understand that the following wires will be needed, based on the diagram of the relay on this page:
BR to Emissions Control Unit, connector M
BW to Ignition ON
L to Fuel Pump, connector L
B to Ground
Br to ??????

So, Br seems to dead end on the diagram, and I don't see anywhere where it picks up on another page, and don't know how to read these diagrams very well in the first place.

Anyone got a Haynes, and know how to read these damned things? If so, could you please let me know where the Br wire will got to?

Thanks!

 

Turn back to page 301 to follow the wire.

 

I don't see Br[F] on page 301... I see a BrY, but isn't that another circuit?

 

Use the FSM link provided thru Trochoids profile.

 

The link is to wankel.net, and I have tried that site all day, getting time-out errors and not able to get the site to come up in my browser....

I'll try again later and see if they're up again.

Thanks,
Daniel

 

Yea! They're Back Up!