well i put the gaskets on the baseplate, guess what, IT STILL ***** UP!!!!!! AHHHHHHHHH!!!!!! i have absolutely no other options. WTF WTF WTF!!!!!!!!!!

 

Give up, send it to Carl, and hope you can recoup the cost later. That's probably what I'm gonna do.

Jon

 

Whats it doing now? Lets give it another try.

 

it's not the carb now. LOL it be a vaccum leak under the carb. it's around the baseplate still. i think i need to get a newbaseplate cause the gasket only helped a little bit.

 

or do what I did... take the carb and baseplate off, get some high-heat red silicon and use that to seal between the intake manifold/gasket/carb. Careful not to plug the little holes.

Then get some new vacuum tube, and replace any tubes that have been removed/replaced (all the ones that hit the carb gasket basically, the rest should be ok) and check the AAB hose.

A vacuum leak I can deal with... the carb ******* over I can't!

Jon

 

yea, that's what i'm gonna try next. i'm gonna use my rtv high heat ****. it's running actually pretty good now but it's still a bit clunky because of the little bit of vaccum leak left. ***** YEA!