1st Generation Specific (1979-1985) 1979-1985 Discussion including performance modifications and technical support sections

Flat spot under acceleration? Help!

Thread Tools
 
Search this Thread
 
Old Nov 3, 2008 | 03:45 PM
  #1  
sa22c[est. 1979]'s Avatar
Thread Starter
Resident N00b
Tenured Member 05 Years
iTrader: (2)
 
Joined: Jun 2008
Posts: 205
Likes: 0
From: Chandler, Az
Flat spot under acceleration? Help!

Hey there everyone. So I have a 79 rx, with a 12a. My problem is, when I floor it, in any gears, the car pulls hard, untill about 4000 rpm, then has almost no power. I figured it might be a fuel delivery issue, but I replaced the filters, the pump was fine, and the carb seemed fine also, but I'm not %100 sure. It's getting really annoying because I need every last one of those 100bhp to make it up the big *** hill to my house.

-Thanks in advance!
Reply
Old Nov 3, 2008 | 03:54 PM
  #2  
NCross's Avatar
I have a rotary addiction
Tenured Member: 15 Years
iTrader: (18)
 
Joined: Jun 2006
Posts: 4,815
Likes: 24
From: Columbia, Tennessee
Try safety wiring your secondary butterfly cam to the rod. They may not be opening right. I did this and it's like a turbo spooling up when I push the gas down further.
Reply
Old Nov 4, 2008 | 05:09 AM
  #3  
trochoid's Avatar
Old Fart Young at Heart
Tenured Member 10 Years
iTrader: (6)
 
Joined: Apr 2004
Posts: 15,145
Likes: 8
From: St Joe MO
I bet the engine free revs fine to 7k rpm, but won't when it's under load. Most likely the exhaust system has collapsed and plugged. Set of headers and a pre-silencer will take care of that.
Reply
Old Nov 4, 2008 | 06:48 AM
  #4  
mazdaverx713b's Avatar
Have RX-7, will restore
Veteran: Army
Tenured Member: 20 Years
Loved
Community Favorite
iTrader: (91)
 
Joined: Oct 2003
Posts: 22,577
Likes: 1,273
From: Ohio
scott's probably right, but you may want to consider a carb rebuild as well. check the plugs, points and condenser, cap, wires, fuel and air filters, and coils just for good measure.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
Oct 17, 2020 03:25 PM
Einheri
Single Turbo RX-7's
14
Oct 7, 2015 12:23 PM




All times are GMT -5. The time now is 01:50 AM.