Fiero fan install question, help please
#1
Fiero fan install question, help please
OK, I got my Fiero fan off ebay a week ago. $27.00 Shipped. Hooked it up to a battery charger and it works good. Well, I remember reading about hooking it up to the thermastat switch in the thermastat housing. The one that controls the choke.
Has anyone done this and is it working good. I will be removing the choke and carb when I get a weber set up. I at least want the switch to be used if its posible.
Thanks
Has anyone done this and is it working good. I will be removing the choke and carb when I get a weber set up. I at least want the switch to be used if its posible.
Thanks
#4
Rotary Enthusiast
The sensor that controls the choke on a 1st gen is on the back of the water pump housing not in the thermostat housing.
I used a REPU themostat housing that has threaded plug I removed and used a Honda switch to turn my fan on/of (wire to a relay)
2nd thermostat housing (not all have a threader switch) but it look too long for me.
John
I used a REPU themostat housing that has threaded plug I removed and used a Honda switch to turn my fan on/of (wire to a relay)
2nd thermostat housing (not all have a threader switch) but it look too long for me.
John
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM