exhaust system - is this feasible?
09-12-01, 02:42 PM
#1
exhaust system - is this feasible?
quick question:
i'm looking into getting a racing beat midpipe w/ a new muffler.
do the racing beat midpipes need to be welded onto the system, or do they have flanges so i can just bolt 'em on to the header?
i ask because my plan is to pull out my entire exhaust system from the midpipe back and replace it with a RB system - and bolt the RB stuff to the header so i can replace my stock exhaust system for when emissions testing time comes around.
is this feasible?
i'm looking into getting a racing beat midpipe w/ a new muffler.
do the racing beat midpipes need to be welded onto the system, or do they have flanges so i can just bolt 'em on to the header?
i ask because my plan is to pull out my entire exhaust system from the midpipe back and replace it with a RB system - and bolt the RB stuff to the header so i can replace my stock exhaust system for when emissions testing time comes around.
is this feasible?
09-12-01, 03:08 PM
#2
Full Member
Join Date: Feb 2001
Location: Las Cruces, NM
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
boltage
it's all bolt-on.
you need to make sure that you keep the supports that hold up the whole system, otherwise, it will drag and eventually break off.
it's a good system, so i hear!
i like the mid pipe (cat replacement)
Josh
you need to make sure that you keep the supports that hold up the whole system, otherwise, it will drag and eventually break off.
it's a good system, so i hear!
i like the mid pipe (cat replacement)
Josh
Thread
Thread Starter
Forum
Replies
Last Post
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM