As best I could find, this issue is not covered in any old posts. If I'm mistaken, please help me find the adequate post from which this information may be gleaned.

I pulled the 12A from my '79 SA, and am currently working on getting it back in. The wiring diagram, however, doesn't seem to be matching up properly. I found a particular connector that is not listed in the USA Model diagram, but is listed in the California Model diagram.

My question is: Does the USA Model use the same wiring harness as the California Model? If so, how can I verify that this engine is not the California model after all?

 

I know my FB Does. I had a few wires that were there, that went nowhere, but were listed on the ca diagram as being part of the ACV system.


whats it go to for the ca car int he manual?

 

The one that I've found that's definitely CA only is listed as "Connector to Transmission Harness." Don't recall seeing a cross-connect from the transmission, but I wouldn't be surprised if this car is mix and match, to be honest.