engine build
Thread Starter
Full Member
Joined: Jul 2002
Posts: 86
Likes: 0
From: Ottawa Canada
engine build
Want to build a NA 13B block, and wondering if anyone sees any problems with putting this together.
89-91 NA Rotors and seals (for lightness)
TII Rotor housings (for larger exhaust port)
TII Intermediate housing (for larger primary ports)
89-91 NA Front and rear housings (for auxillary ports)
I don't know if all these parts are compatible but hopefully someone has had experience with some parts interchange.
89-91 NA Rotors and seals (for lightness)
TII Rotor housings (for larger exhaust port)
TII Intermediate housing (for larger primary ports)
89-91 NA Front and rear housings (for auxillary ports)
I don't know if all these parts are compatible but hopefully someone has had experience with some parts interchange.
Thread Starter
Full Member
Joined: Jul 2002
Posts: 86
Likes: 0
From: Ottawa Canada
Jeremy
I know there will be a problem if you use a GSL-SE side housings and a TII rotor housing because they moved the o-ring groves from the rotor housing to the side housings for the 2nd gen. So, you wouldn't have a groove for the o-rings to sit in. I'm sure you could always make a groove though.
I know there will be a problem if you use a GSL-SE side housings and a TII rotor housing because they moved the o-ring groves from the rotor housing to the side housings for the 2nd gen. So, you wouldn't have a groove for the o-rings to sit in. I'm sure you could always make a groove though.
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
Sep 5, 2015 10:23 AM
rx8volks
Canadian Forum
0
Aug 13, 2015 04:55 AM