Dowel pins or bolts???
Thread Starter
Banned. I got OWNED!!!
Joined: Mar 2005
Posts: 564
Likes: 0
From: SF CALI
Dowel pins or bolts???
I have the tranny and flywheel out of the car.............can i tighten the bolts holding the motor together? is that a good idea?........torque specs? 
I'm bored
I'm bored
boost my 7
Joined: Jun 2004
Posts: 884
Likes: 0
From: Colfax, Washington
why would you wanna tighten the bolts on the motor? pull it apart, port, and rebuild it if you are really that bored. tightening the engine wont help much unless it has somehow gone out of stock torque specs (about 90ftlbs i think?).
Thread Starter
Banned. I got OWNED!!!
Joined: Mar 2005
Posts: 564
Likes: 0
From: SF CALI
Hmmmmm I have about 40k in my rebuild......so i dont think i want another one(YET) .......Just a question sorry...................90? i remember reading somewhere ,it was about 28 or so? Just another question.......I'm a NOOB!
.......Just a question sorry...................90? i remember reading somewhere ,it was about 28 or so? Just another question.......I'm a NOOB!
Thread Starter
Banned. I got OWNED!!!
Joined: Mar 2005
Posts: 564
Likes: 0
From: SF CALI
Originally Posted by TurboSE
Hmmmmm I have about 40k in my rebuild......so i dont think i want another one(YET) .......Just a question sorry...................90? i remember reading somewhere ,it was about 28 or so? Just another question.......I'm a NOOB!
.......Just a question sorry...................90? i remember reading somewhere ,it was about 28 or so? Just another question.......I'm a NOOB!
Thread Starter
Banned. I got OWNED!!!
Joined: Mar 2005
Posts: 564
Likes: 0
From: SF CALI
Originally Posted by gsl-se addict
Yes, they are suppose to be 23-27 ft-lbs. I wouldn't worry about them. They were probably torqued just fine to start with.
Thread
Thread Starter
Forum
Replies
Last Post
erevos
2nd Generation Specific (1986-1992)
4
Sep 15, 2015 09:19 AM
