choke cable!
06-06-03, 09:57 AM
#1
Banned. I got OWNED!!!
Thread Starter
Join Date: Dec 2002
Location: wishing i was back in FL
Posts: 4,192
Likes: 0
Received 0 Likes
on
0 Posts
choke cable!
can anyone tell me how the damn choke cable goes back on ? i have an 84 carb. 
better yet, anyone got a pic? hahahha, i might be able to figure it out, but i want to be ready. i'm gonna be putting it back on in about a couple hours. thanks guys
better yet, anyone got a pic? hahahha, i might be able to figure it out, but i want to be ready. i'm gonna be putting it back on in about a couple hours. thanks guys
06-06-03, 10:14 AM
#2
Full Member
Join Date: Feb 2003
Location: Boise, ID
Posts: 96
Likes: 0
Received 0 Likes
on
0 Posts
I don't have a pic, but it's pretty straight forward. It goes in the top hole, which is above the throttle cable. Put the cable end in the cam, then put the housing stop in the hole. The adjustment is the hard part. I haven't quite gotten that figured out.
06-06-03, 07:34 PM
#3
Airflow is my life
After the cable end is on, pull back till the threaded part clears the bracket, slide it into the slot, let it bottom till the nut rests on the bracket, install clip. It wont go out of adjustment if you didnt mess with it too much.
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
09-30-15 08:13 PM