I'm looking for the chassis dimensions of the car. It's usually a shot from underneath showing the distance between points. Normally found in chassis or body shops to see if the frame is running strait. I found some damage in the front end of my car after removing the fenders, bumper, valance, ect. Looks like metal was replaced in a large enough area to be a decent front end colission on one side. I need to be sure this car is strait before I get to deep into it...

It's an non SE 85.

 

It can be found at Foxed.ca

http://www.foxed.ca/rx7manual/manual...X7(14)Body.pdf

 

Thanks!!!!!

 

Also in the back of the service manual.

 

it's in the '85 FSM chapter 14, the last page.