I tried searching and came up empty but is there any information on putting webers on a EFi 13b im tired of dealing with the stoopid littile ticks with with the current fuel system

thanks in advance

 

Same as putting a Weber on any other rotary, except that you need either a low-pressure fuel pump or a bypass-style fuel pressure regulator like the Mallory 4309.

 

RB makes a UIM that bolts to the stock LIM. Then use a side draft Weber or Dell 48.

 

If your running fuel injection, you'll need to block off the injector ports, then if you want to save some headaches, pull the sleeves and actuators from the intake and manifold (if you have a 6 port ) Then buy an RB upper intake manifold, and your ready to go. I just did this with an SE motor and put a 48 Dellorto on. Or you can also buy an intake and go with a downdraft style carb too, or a Holley for that matter.

 

actually u can just leave the injectors in the center housing rather than buy the block offs for them. other than that all u need is the carb and upper intake to bolt to the lower intake and a fuel pressure regulator with return.