Carb question
#1
Junior Member
Thread Starter
Join Date: Dec 2004
Location: Pensacola Florida
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Carb question
I might be getting my friends carb from his 1st gen. He somehow flipped it, and everything is pretty much ruined eccept for a few parts. Because it was upside down, the float is apparently stuck, and I know that is important, would it be simple to unstick it? Someone told me I would have to "tap" it back in place, but he didnt specify what that ment. Hopefully this will end my car troubles..
With my luck, I ended up with one of the only first gens with almost perfect interior and nice looking exterior in my town, yet it dosnt run properly, when everyone else has a bad interior and exterior, but their car runs great (great for a first gen).
With my luck, I ended up with one of the only first gens with almost perfect interior and nice looking exterior in my town, yet it dosnt run properly, when everyone else has a bad interior and exterior, but their car runs great (great for a first gen).
#2
Lives on the Forum
You might be able to unstick it by banging on it, but if it has been out of use for a while you might want to go ahead and rebuild it at this time.
There might also be fitment/use issues if it is from an older model. Good luck.
There might also be fitment/use issues if it is from an older model. Good luck.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM