Carb probelm
Thread Starter
Junior Member
Joined: Jan 2006
Posts: 12
Likes: 0
From: MinneSNOWda
Carb probelm
AHHHH!!! get the carbs apart with ease and run into a HUGE issue... The "ball, check, pump discharge" check ball WONT come out of the carb bodie!! I cant seem to get it out, tried hitting both sides with a rubber mallet, tried grabbing at it with a tweeser tried soaking it in carb cleaner, tried soaking it in special carb bath cleaner, tried to superglue a brass rod to it and NOTHING is working...
advice, please. If I could find where the inlet is (The other side) of this check ball thing I could put 90 PSI of air pressure at its butt and send it flying through my wall but I cant seem to locate that either... ARGH.
please, help, me...
(PS, I have the hygrade kit with replacement check ***** so destroying the ball IS an option...)
advice, please. If I could find where the inlet is (The other side) of this check ball thing I could put 90 PSI of air pressure at its butt and send it flying through my wall but I cant seem to locate that either... ARGH.
please, help, me...
(PS, I have the hygrade kit with replacement check ***** so destroying the ball IS an option...)
Senior Member
Joined: Nov 2005
Posts: 296
Likes: 1
From: Madison, AL
look here https://www.rx7club.com/1st-gen-archive-71/fuel-intake-carb-manual-online-380352/
there is a link to the mazda carb factory service manual
there is a link to the mazda carb factory service manual
Thread
Thread Starter
Forum
Replies
Last Post