A quick question regarding sealed ball joints. I purchased two from Blackdragon and they are sealed units with no zerk fittings. Do I need to grease them or are they pre-greased? Thanks in advance.

 

Usually if they are sealed than they are pre-greased. Can you peak in the boot and see if it has grease?

 

you should check for grease. if they decided to make them cheaper, they will leave out the grease

 

Agreed if it is a sealed unit then it probably has grease in it already, but peeking under the boot can't hurt...unless you tear the boot...so be careful

 

Okay. Looks like they are pregreased. I put a thin toothpick down the side of the shaft and gently pulled it back out. It had grease on the end so I think I'm good to go! Time to get her back on the road! Thanks.

 

What they said, check it, but it should be greased. Every ball joint I've ever bought (and it's been a lot!) have come pre-greased, but can't hurt to look.