ok bought a used header of here and it had some tiny flange that was obviliously not the right one(could tell from the "nice" welds!) So I cut it off alot higher and used some 2.875 id pipe from work and fabed it on with a 3" "v-8" flange,wich then reduces from 3 back to 2.5" wich is what my exhaust is. Question is,is will that be ok? I see the road race header has 2, two inch outlets so I am guessing one 3" should be fine? Heres some pics.Oh,yeah its going on a stock port 12a with the race beat holley set up.