Any Detailed Holley Installation Instructions?
#1
Gen 1 4 life
Thread Starter
Join Date: Jul 2004
Location: Apalachin NY
Posts: 587
Likes: 0
Received 0 Likes
on
0 Posts
Any Detailed Holley Installation Instructions?
was searching for a while to get some detailed instructions for the holley install on an fb. with all the vaccuum lines that went on the nikki, and going from 2 gas inlets to 1 inlet and an outlet, and all that jazz, where the oil line goes, etc.. anyone have one on their cardomain or have a thread saved from earlier? maybe a site somewhere? im not coming up with any good results..
last thing in the way of my turbo going on, so im a bit anxious.. going to put the nikki on and get it inspected before the end of the month, but after that, high hopes..
last thing in the way of my turbo going on, so im a bit anxious.. going to put the nikki on and get it inspected before the end of the month, but after that, high hopes..
#2
Moderator
iTrader: (2)
first u'll need to upgrade the FP, the holley needs around 6psi. remove all the vac lines. install inline fuel filter in the suply line to the holley and cap off the return line at the firewall. for the OMP, get a 1/16 nipple and put in the primary bowl where the float level plug is. get a vac "T" from any auto parts store, but it needs to be in the shap of an "F". this will go upside down at the OMP. this converts the 2 lines off the pump into 1 line up to the 1/16 nipple u put in the primary bowl on the holley. as for the throttle hook up, ur on ur own. the RB setup is made for the cable in the rx7, and comes with the cable braket. good luck!
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM