Another update with my car...Im so excited
#1
Another update with my car...Im so excited
Sorry about all these posts with me "updating" my project. Theres nothing special about it, but Im just proud that I actually stuck with it and didnt give up when I wanted to . So, anyway, what I have so far is the engine and tranny bolted together with a new clutch, pressure plate, flywheel, pilot bearing, pilot bearing seal, release bearing, and new front and rear tranny seals. I also have my new thermostat and gasket in place, as well as my RB header and both blockoff plates installed and sealed off with the air pump removed. The new oil pan and gasket are also on. Right now the entire assembly is sitting in the car with the front engine mount nuts on, and a jack holding up the back . The next thing Im doing is the tranny crossmember and driveline. Then I have to figure out the cooling, cause the radiator I have has an electric fan on it, but I dont know where the zillion wires are supposed to go. After that, I just gotta hook all the tubes, wires and cables up and start her up .
~T.J.
PS - If anyone has instructions on how to wire my fan, I would appreciate it. It looks JUST LIKE the one in Victoria British.
~T.J.
PS - If anyone has instructions on how to wire my fan, I would appreciate it. It looks JUST LIKE the one in Victoria British.
#2
Rotary Freak
iTrader: (1)
Join Date: Feb 2002
Location: NJ
Posts: 2,693
Likes: 0
Received 0 Likes
on
0 Posts
Neato! Sounds exactly like what I did, except no electric fan...yet. You should wire the thermostat midway between the ignition 'on' and the fan. That might be a bit harder, but it's just a suggestion.
Thread
Thread Starter
Forum
Replies
Last Post