Adjusting holley carb!
#1
Full Member
Thread Starter
Join Date: May 2002
Location: Texas
Posts: 179
Likes: 0
Received 0 Likes
on
0 Posts
Adjusting holley carb!
anyone know how far in the mixer screws on the side need to be! I rebuilt a holley thats going on my 13b and i dont want it to mess up the carb!
#2
If it is the screws in the side of the metering plate then they are the air/fuel adjustment screws for the idle. You will need to adjust these when the car is running. I would turn them all the way in then out a turn and a half to get it started. Then adjust each one turning the screw in untill the engine starts to stumble. Then back the screw out about a 1/4 turn. Proceed with the other side. This is how I adjusted them on my mustang, it worked great. Hope I could help.
Chach
Chach
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM