TheDriver216

iTrader: (2)

Well i installed a weber 45 dcoe from a forum member.. everything is hooked up.. problem is when i start it it it runs fine with the choke on.. 2k rpm steady no problems.. now when after i let it warm up and close the choke it accelerates up to about 3.5k rpm then comes crashing down and dies.. any ideas?.. i was told it ran before it was pulled off. new to weber carbs.. i havnt advanced my timing yet either ..

pinoyremix

i think the answer is in here:

https://www.rx7club.com/showthread.p...light=weber+45