13B swap Wiring Details needed...
#1
Rotartist
Thread Starter
iTrader: (13)
Join Date: Sep 2003
Location: Spring Hill TN 37174
Posts: 7,252
Likes: 0
Received 2 Likes
on
2 Posts
13B swap Wiring Details needed...
Ok I have strung Up a new wiring harness I have A few questions....
1) where does 1s from the ECU go to what do I hook i up to? (the fsm says Port air soilienoid) where is that? Does it pick up any additional leads at that point?
It is a brown and RED lined wire....
2)Water temp hooks up to the sensor on the radiator correct? (brown with whiteline) (1h)
3) 1C Where the fubar does this one go and does it pick up any on the way?
4) am I going to need a nuetral switch or 5th switch or both, or can they go bye bye?
Which pin gets power TO THE ECU?
5) on the trailing coil (rear) what does the 4th wire (yellow with blue stripe) do and wher does it hook up?
6) where the hell does the initial set go to and why? What does it do?
ANY HELP WOULD BE GREAT!!!!
The FSM isn't answering my questions....
1) where does 1s from the ECU go to what do I hook i up to? (the fsm says Port air soilienoid) where is that? Does it pick up any additional leads at that point?
It is a brown and RED lined wire....
2)Water temp hooks up to the sensor on the radiator correct? (brown with whiteline) (1h)
3) 1C Where the fubar does this one go and does it pick up any on the way?
4) am I going to need a nuetral switch or 5th switch or both, or can they go bye bye?
Which pin gets power TO THE ECU?
5) on the trailing coil (rear) what does the 4th wire (yellow with blue stripe) do and wher does it hook up?
6) where the hell does the initial set go to and why? What does it do?
ANY HELP WOULD BE GREAT!!!!
The FSM isn't answering my questions....
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
The Shaolin
2nd Generation Specific (1986-1992)
9
09-14-15 07:50 PM