Mine are not so good. Is this available new from anywhere ? Is there a substitute extruded rubber profile that can be used ? Any help or direction is appreciated.

 

there is no direct replacement available from mazda. you will have to fabricate a new outer gasket.

 

Yeah people have been looking for a replacement for these for years.

I ended up just going to a rubber/foam stockist and bought some foam "tape" that had a sticky side that you peeled the backing paper off and was around a 1/4 inch thick, but compressed very easily down to about 1mm or so.

I took the lights off, cut up the foam "tape" and stuck it to the lights where the old gasket sat. Then re-bolted the lights to the car and tightened them up.

It worked a treat and hasn't leaked once.

It looked like this stuff, you remove the yellow paper backing to reveal a sticky underside....only mine wasn't that thick or wide....but you get the idea.



Cam...

 

According to Mazdatrix you can still get'em.....

http://www.mazdatrix.com/n-1.htm

 

Nope ^

They only have the ones for SA's available.

 

sweat i need them