Louvers Question
#1
Rotary Freak
Thread Starter
iTrader: (19)
Join Date: Oct 2007
Location: Colorado Springs, CO
Posts: 2,014
Likes: 0
Received 0 Likes
on
0 Posts
Louvers Question
I have the factory aluminum louvers on my car. They are missing the 2 metal bars that hold them up to clean the glass. I wanted to try and build new ones and had a few questions about them.
1. How long are the and what is the diameter?
2. How do they mount to the supports
3. What do the plastic tabs they snap into look like? (mine are broke off)
4. Can I get some good pics of them?
1. How long are the and what is the diameter?
2. How do they mount to the supports
3. What do the plastic tabs they snap into look like? (mine are broke off)
4. Can I get some good pics of them?
Trending Topics
#8
Senior Member
iTrader: (1)
Join Date: Oct 2010
Location: oregon
Posts: 484
Likes: 0
Received 0 Likes
on
0 Posts
i can measure them for you if you like, but if i was you, I'd take a bar and extend it from the hole they mount in to almost the bottom of the louvers. the bars that they come with are too short. they're held in place with a clip that's mounted on there, also. you just snap them in place. the aren't very big around, smaller than a pencil.
#13
Senior Member
iTrader: (1)
Join Date: Oct 2010
Location: oregon
Posts: 484
Likes: 0
Received 0 Likes
on
0 Posts
if you look down there at the bottom it just does a 90 and goes through a hole, there is a groove but both of mine appear to be missing the clip, I'd just drill a hole through it and put a cotter pin in it, myself.
Thread
Thread Starter
Forum
Replies
Last Post
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM