Ok so i have a 13b gtu that is bridge ported and has 3mm apex seals. I want to make my car turbo so i am buying a turbo 2 engine. And my question is, can i use my rotors in the t2 setup and have bridge ported as well?

 

Why not use the rotors from the tii

 

I'm just saying in case those are bad i can use mine. And i heard high compression rotors with turbo is a good setup if done right. I am not knowledgeable about the subject though

 

you would have to get the correct counterweight(s) to have the rotating assembly balanced

 

Well I've heard the same about s5 rotors been used cause they are stronger but am sure that there gotta be some tricks like balancing and milling them. I would at least balance them if you plan on making big power