Does anyone have templates available? If so, could you trace the templates onto cardboard and send them to me for around $20 or so shipped?

 

 

I'm not an expert, but I've read it's hard to bridge a 6-port motor because of how little material there is.

You can read more at here

Good luck!

P.S. If you find those templates, send me a set!

 

everything i have heard was that people say its not worth it. then again i dont htink i have even heard of anyone wiht one, i am sure they are out there.

 

I just took a look at my intake ports, a bridge-port would be very difficult, if even possible.

 

switch to a 4-port motor and bridge it?

 

There was an old GLC with a 13b 6-port bridge that ran 10's-11's down in the Orlando area in the past...

 

Not trying to sound like a dick here, but just buy the templates. Thats like people copying the Atkins rebuild video for people to download. People work to make this stuff for us, the least we can do is buy it to finance future endeavours by them for us. Besides, templates are pretty cheap arent they? Theyre only like $40 man.

~T.J.

 

All the porting templates i've seen are going to cost me around $100 after shipping. If i can get the same job done for a cheaper price why pay more? I can put that extra $80 towards something else.

 

Why do the homework when you can copy?


Yeah, I see RotorMotorDriver's point... Someone put the time into developing the porting, you might as well support them... that way they'l have cooler stuff next time you want something