Haltech 13B Cosmo E11V2 first start
#1
In rotor we trust!
Thread Starter
Join Date: Aug 2004
Location: Moscow, Russia
Posts: 258
Likes: 0
Received 0 Likes
on
0 Posts
13B Cosmo E11V2 first start
My cosmo started yesterday since I bought it in 2004
I made a fully custom wiring with race switch panel and a lot of relays.
It started with ease but only on first section. I have a problem with stock ignition module witch didnt fires T2. I have problems with second leading spark plug as well.
I bought an autronic 500R but didnt mount it yet. I think it will solve T2 problem.
I try to zeroing timing. The timing light hits near the yellow mark (hits right). I set the tooth offset as 3. Lock -5 ( 5 for better start).
Should I play with trigger angle? I have better results when I up an angle.
I have a crazy hi idling. I have no corrections yet.
Its time to tune...
Video:
http://www.youtube.com/watch?v=WzzxZdBwUjs
I made a fully custom wiring with race switch panel and a lot of relays.
It started with ease but only on first section. I have a problem with stock ignition module witch didnt fires T2. I have problems with second leading spark plug as well.
I bought an autronic 500R but didnt mount it yet. I think it will solve T2 problem.
I try to zeroing timing. The timing light hits near the yellow mark (hits right). I set the tooth offset as 3. Lock -5 ( 5 for better start).
Should I play with trigger angle? I have better results when I up an angle.
I have a crazy hi idling. I have no corrections yet.
Its time to tune...
Video:
http://www.youtube.com/watch?v=WzzxZdBwUjs
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM