You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
I tried that. It only has oil flow in the lubrication section. There is no cutaway diagram in the cooling section, which is what I'm pretty much looking for.
__________________ - Audi A4 1.8T Quattro
- Mazda RX-7 GSL-SE
in curious exactly what did you mean by when u said it was gonna go into the band saw? what were u planning to do with the irons?
that is of course if you dont mind me asking.http://www.rx7club.com/images/smilies/smile.gif
I was going to cut them in half parallel to the working surface, in the middle so that I could examine the cavity and figure out coolant flow that way. I still might do that... I don't know yet... but the diagram helped out a lot!
__________________ - Audi A4 1.8T Quattro
- Mazda RX-7 GSL-SE
Linear Mode
