Tootothed pulley and belt.
#1
Rotary Freak
Thread Starter
Join Date: Nov 2001
Location: trinidad and tobago
Posts: 2,715
Likes: 0
Received 0 Likes
on
0 Posts
Tootothed pulley and belt.
I know that I am getting a good amount of slippage at high RPM's with the stock pulley and removed air pump . I cant use one of the fancy add on additional pulley kits 'cause my turbo sits where the air pump used to be . I was wondering if there is an aftermarket coged (with teeth on them) water pump pulley and belt combo available for the FD .
#3
Tequila? ..it's like beer
iTrader: (1)
Join Date: Mar 2001
Location: Woodbine, MD
Posts: 1,124
Likes: 0
Received 0 Likes
on
0 Posts
Do you have enough room to set up something like this?
https://www.rx7club.com/showthread.p...ulley+solution
If you're not worrying about running any accessories and the noise from the belt, you could try to bolt on one of these:
http://www.tweakit.net/shop/product_...roducts_id=430
They only refer to 1st and 2nd gen kits though.
https://www.rx7club.com/showthread.p...ulley+solution
If you're not worrying about running any accessories and the noise from the belt, you could try to bolt on one of these:
http://www.tweakit.net/shop/product_...roducts_id=430
They only refer to 1st and 2nd gen kits though.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM