would this fuel setup work with the wolftek ecu with built in 2bar map........http://www.rx7store.net/product_p/extremefuel.htm

 

It would work. What exactly are your goals before going out and buying a fuel system like that? I'm using all stock fuel hardware except a walbro pump, 1680 secondaries, and rc 1000 primaries. stock rails, stock fpr, stock lines... it supports over 500hp. I can't imagine needing that hardware if youre only going to be using the wolfs map sensor (which goes up to 23psi, not 2 bar)

 

im gonna run a turbonetics t3/t4 62-1 so ill prolly run only 20psi..i like what ive seen with the wolftec i just dont want to switch to a standalone

 

i'm not sure what wolftec is, but this is the wolf3d forum

http://wolfems.com.au