hi i need some help with wolf set up mine setup is a s6 93 r1 rx7 single turbo n&w cdi ignition with 4 coils now my problem is that the trailing coils don't fire the triggers in the s6 are fixed two hall sensors and rpm is reading to low when crank around 150 rpm whats the triger sequence reset count is set to two now then 0 and 5 5 on the rest of the table and the rpm divider to 120000 is this all correct i'm using the ref & sync. it seen to be reading something low can some one help me with this thanks...

 

hey, welcome on board.

Can you post your map?

I will arrainge it for you. that would be the easiest way. I have a s6 PnP ecu, vers 4.61

George

 

ok i will try since i'm new here something else this map is for a full sequential ignition if you notes the fire all ignitions 1234 one for each coil

 

ok, so is this a wire in unit or is it the plug n play? I ask because it depends on the wiring config. what ignitor are u using? stock?

 

it is a wire in unit and i'm using a n&w cdi pro 14 ignition is a four channel cdi igniter box with four coils is a complete setup to run from wolf ecu
ramces...