Wolf 3D Question for Wolf
Question for Wolf
Ok Guys I have been trying to tune my wolf Version 4 for amost a month with little luck . I currently have an 86 base but have installed a 89 - 91 T II , stripped all the emmissions , Ac, Power steering . Added Racing beat ex, brembo drilled and slotted rotors , Tokico 5 way adj with ground control coil overs , Racing beat from sway bar and finally this Wolf 3D . I am simply trying to get the car to run well stock,but this is turning out to be a chore . I can get he car running and even drive it , but when stomping the gas is seems to be getting either to much gas or not enough spark . I have put the engine 60 degrees advanced and made sure the crank angle was set up right . Today a ran another 12 volt line into the leading ignigtor. I did notice it seemed to react better , but not a ton of difference . i have used a lap top to try and lower the amount of fuel / along with trying lean it out a bit with no luck . I have a T66 turbo with a Sperco front mount to add after I get this part done . Does anybody have any sugestions or know of someone in the Va area who could help
You can either send me or chris your map and maybe i can figure out whats wrong. Actually just send it to me, if i cant figure it out, then ill forward it to him.
rxsevent2@hotmail.com
Graham
rxsevent2@hotmail.com
Graham
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic S5 Turbo PNP Unit questions
_Tones_
Adaptronic Engine Mgmt - AUS
10
May 25, 2021 05:37 AM
Nosferatu
2nd Generation Specific (1986-1992)
7
Sep 5, 2015 02:13 PM



