anyone with write up on wireing 3d.v4 with cas
well i have a wolf 3dv4 and what do i need to hook it up with stock cas and coil packs has any one hooked it up with stock coils and cas any diagrams floating around
|
Originally Posted by dennis blackstone
(Post 7442748)
well i have a wolf 3dv4 and what do i need to hook it up with stock cas and coil packs has any one hooked it up with stock coils and cas any diagrams floating around
I've posted writeups and diagrams. this forum doesn't have too many posts, try searching. |
thanks nyt ill look for it ...by the way was it a succesfull install
|
I run a stock cas
Stock coils work but the ignitor will not unless you have ordered your ems flashed to allow it to control the overenginnered trailing ignitor Just buy a FD ignitor, which is a 3 channel unit, and you can control all 3 coils from it, or just the trailing if you wish CAS writeup https://www.rx7club.com/showthread.p...ght=CAS+Wiring Ignitor write up https://www.rx7club.com/wolf-3d-125/howto-fd-igniter-wolf-3d-v4-389233/ g'luck, post more questions if ya got em, however most wiring thiings have been covered so feel free to search |
+1 for fd igniter, i got one for $25
|
just buying the one fd ignitor is all i need? for ignition and i wire that to the plug near the battery for the leading coil ,,,by the way i have a msd will that do it and how i wire that up ..sorry for all the questions i read a few post but my electronic skills suck thanks guys for any info
|
best ignition setup you can use is fc coils, fd igniter, and an msd 6a on the leading coils. imo
|
nyt how do you put all thi together do you take the ignitor out of the fd boy im confused
|
dont bother putting in the msd box yet, get the car running without it first
the second link has all the wiring for the igniter |
crackheadme do you have a pic of this im so lost with schematics or if you could draw it sorry for being so dum
|
per nyt..
This is looking at it with the pins on the igniter facing up, looking at the top side of it. Pins from left to right. This matches up with the diagram on page G-16 of the FSM. Make sure you have the connector from the FD harness with the igniter also. PIN 1 - Trailing Wolf (T1) PIN 2 - To Trailing Coil (T1) PIN 3 - Trailing Wolf (T2) PIN 4 - 12V IN (switched) PIN 5 - To Trailing Coil (T2) PIN 6 - Leading Wolf PIN 7 - To Leading Coil PIN 8 - Unused (bridged to pin 7 inside the igniter) from the FSM. http://www.countercultured.net/pics/fdigniter.jpg |
so wire pin1 to wolfs' trailing 1 ignition output
pin 2 to the trailing coil pin3 to the trailing coil 2 wolf output so on and so forth |
crackheadme your the best thanks so much ....any info for the for wires on the cas..which wires from the wolf to splice into the cas connector
|
All times are GMT -5. The time now is 05:41 AM. |
© 2024 MH Sub I, LLC dba Internet Brands