I have an 84 and am getting a T-5 put together for me, and the guy asked if the angle it sits at would bother me… truthfully I have no clue what the angle a transmission would sit at would change for me.

Secondly I was curious if any cutting to the OEM shift hole was needed for a T-5, Thanks!

 

what engine?

 

I have a 327 out of my 64 impala

 

my t5. 1980 w 350. You’ll need to cut a little more hole toward the back, but it fits. The tranny leans a little toward the driver

 

Sweet that's exactly what i need to know, I do wanna know what case and shaft you used. I'm not certain on what I need.

 

Mine is out of a 90 Camaro v8

 

I made an adapter plate to mount a T5 to an old school SBC bell housing so the shifter was straight up and down. I offset the shifter so I didnt have to cut the body panel and even use the factory Rx7 shift boot and ****, it ended up looking pretty nice in the end.