Racing Beat Exhaust matchup?
 

Will a Rev TII exhaust matchup with an LS1/2/3 motor? Or is it just not beneficial to run it? I am getting all my ducks in a row before finally committing 100% to a swap.

Thanks

Justin

Interesting question. Assuming a few things:
1) you're talking about the turbo-back REV TII exhaust, right?
2) the LS engine was turbocharged
3) you could somehow get the turbo to be in the same spot as stock turbo (I think impossible, but could be wrong)
4) the new turbo used the same exhaust flange
5) you wanted to run 3" exhaust with a turbocharged LS motor
6) you wanted to LS swap your turbo II :'(

...or 7) you mean to go NA and had some headers and mid pipe custom made to match up to the racing beat y-pipe (some have done it: https://www.rx7club.com/v-8-powered-...-swap-1112797/ ) Seems reasonable enough.

I am looking to buy a complete REV TII exhaust so hmu if you're going to sell it :P

I would just use the catback and sell the dowpipe/resonator. I made over 500whp with a rotary through an older RB TII catback, you'll be fine. It will likely be on the quiet side. If you want something louder looking into building your own exhaust.