RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   Time Slips and Dyno (https://www.rx7club.com/time-slips-dyno-128/)
-   -   12.89 on the stock turbo (https://www.rx7club.com/time-slips-dyno-128/12-89-stock-turbo-1016693/)

antman0408 11-03-12 02:15 AM

12.89 on the stock turbo
 
1 Attachment(s)
s4 engine small streetport
stock turbo
corksport exhaust
1600 secondaries
walbro fuel pump
greddy fmic
haltech e6k
act clutch
re01 tires

Went a couple weeks ago on a wednesday night when not many people were there. Got 25 runs in the two hours I was running. This was the best of the night. Boost was in the high 12s most of the night, hit low 13s for a few runs. Wanted to turn it up more but it wouldnt go any higher. Finally was able to break into the 1.9s on the 60 foot.

1SWEET7 11-14-12 01:27 AM

Amazing time for a stock turbo! Do you know what your intake temps were at doing that many runs?

2slow4stock 11-14-12 07:03 PM

Nice! I can't wait to see what my set up does. Also what map are you running, and who tuned it?

rx7_13brew 11-14-12 07:25 PM

pretty good, I managed to hit 12.5 at with 12psi and basic bolt ons and street tires

Customisbetter 11-14-12 07:32 PM

That is awesome! Didn't Aaron's Bridgeport turbo with 400-some horsepower only hit the 13s? I'd say you have some real driving skill there.

antman0408 11-15-12 01:19 AM


Originally Posted by 1SWEET7 (Post 11286065)
Amazing time for a stock turbo! Do you know what your intake temps were at doing that many runs?

Temps were in the mid 90s at the line and went up 10 degrees by the end. Almost all the runs were like this. Air temp was around 70 if I remember right. I think the air temp sensor heat soaks a little having it in the elbow.

antman0408 11-15-12 01:21 AM


Originally Posted by 2slow4stock (Post 11286740)
Nice! I can't wait to see what my set up does. Also what map are you running, and who tuned it?

I started with a basic map the haltech section and made changes to the timing and fuel. I guess you can call it my own map since I did all the tuning.

sharingan 19 11-15-12 09:48 AM

Nice time!
Can't wait to get my high comp turbo setup tuned a and see what I can squeeze out of the stock turbo.

jabroski 11-15-12 11:30 AM

nice! makes me feel better about my build, practically the same setup with a slightly modified stock turbo, whats the HP?

SpeedOfLife 11-15-12 11:30 PM


Originally Posted by Customisbetter (Post 11286777)
Didn't Aaron's Bridgeport turbo with 400-some horsepower only hit the 13s? I'd say you have some real driving skill there.

If so he might have taken it easy on launches because I think he was using the NA differential (which won't put up with as much abuse as the TurboII diff).

abc 11-15-12 11:40 PM

WOW, 25 runs. That's more impressive than the 12 sec pass if you ask me. Congrats on the stock twins layin it down!

MrGoodnight 11-16-12 12:58 AM


Originally Posted by abc
WOW, 25 runs. That's more impressive than the 12 sec pass if you ask me. Congrats on the stock twins layin it down!

Twins?

antman0408 11-17-12 01:46 AM

1 Attachment(s)

Originally Posted by jabroski (Post 11287327)
nice! makes me feel better about my build, practically the same setup with a slightly modified stock turbo, whats the HP?

here's what it put down earlier in the year. I dont have a real boost controller, just a homemade ball and spring one, so boost isn't consistent through the whole rpm range. Peak pressure was 11.8 around 5000 rpms.

rpm pressure
2500 2.9
3000 7.2
3500 8.1
4000 9.6
4500 10.8
5000 11.8
5500 11.0
6000 10.0
6500 9.4
7000 7.4
7500 7.2

antman0408 11-17-12 01:52 AM


Originally Posted by abc (Post 11288031)
WOW, 25 runs. That's more impressive than the 12 sec pass if you ask me. Congrats on the stock twins layin it down!

There was no line so once I got back to the staging lanes I was at the line. I was running for a little more than two hours and didnt really take any breaks between runs except for about 10 minutes after running for an hour.

Just one turbo.

PhillyRX 11-17-12 03:56 PM

Awesome man! Atco? S4 t2 rotors?

antman0408 11-18-12 01:53 AM


Originally Posted by PhillyRX (Post 11289440)
Awesome man! Atco? S4 t2 rotors?

This was at cecil county. Hoping to get to atco before they close this year.

Yup s4 turbo rotors.

Judge Ito 11-22-12 10:10 AM

nice run antman.. on a different note, there is more to mazda stock parts then meets the eye.. my kid ran 12.4@109mph S4 engine, STOCK TURBO,STOCK INTERTCOOLER, STOCK COILS, STOCK FPR. STOCK ECU, STOCK AIR FLOW METER... just a ported engine,larger injectors,upgraded fuel pump... 1.6 60ft mark and 7.9 in the 1/8 mile.. everybody and their mother said it was IMPOSSIBLE!! but guess what... its very possible.. car could have ran an easy 12.0 or 11.9 with the stock parts.. i say could have because the car is getting some upgrades.. all the stock parts that made my kids car run 12.4 will be up for sale..

and the 12.4 run was done with 9-10lbs of boost

Spirit-RE 11-22-12 01:46 PM

Very impressive time.

antman0408 11-26-12 04:48 PM


Originally Posted by Judge Ito (Post 11294176)
nice run antman.. on a different note, there is more to mazda stock parts then meets the eye.. my kid ran 12.4@109mph S4 engine, STOCK TURBO,STOCK INTERTCOOLER, STOCK COILS, STOCK FPR. STOCK ECU, STOCK AIR FLOW METER... just a ported engine,larger injectors,upgraded fuel pump... 1.6 60ft mark and 7.9 in the 1/8 mile.. everybody and their mother said it was IMPOSSIBLE!! but guess what... its very possible.. car could have ran an easy 12.0 or 11.9 with the stock parts.. i say could have because the car is getting some upgrades.. all the stock parts that made my kids car run 12.4 will be up for sale..

and the 12.4 run was done with 9-10lbs of boost

What wheels and tires was she running? I want to get a pair of slicks and be running those times, maybe next year if I have the money to.

antman0408 12-06-12 12:35 AM

Going back to the track this weekend, hoping for better times with the cooler weather.

Carnifex 02-16-13 12:29 AM

thats sick man

wthdidusay82 02-16-13 10:14 PM

Makes me wonder what my car will run, I'm thinking to run a fast time like that you need to be launching and shifting like a pro.

Rotary >Pistons


All times are GMT -5. The time now is 11:14 AM.


© 2024 MH Sub I, LLC dba Internet Brands