Where to get a 3", 3 or 4 bolt dp flange
I want to buy a pair of 3", 3 or 4 bolt downpipe flange for my turbo and dp. It has a v-band on it now but, I've had bad expierences with them leaking all the time and I don't feel like dealing with it on this setup. Where can I buy a nice set?
Thanks, Silvio |
try atp turbo
http://www.atpturbo.com/Merchant2/me...egory_Code=FLS i having the same issues with my a-spec gt35r kit i going to weld both vband flanges together |
Originally Posted by unvmyrx7
try atp turbo
http://www.atpturbo.com/Merchant2/me...egory_Code=FLS i having the same issues with my a-spec gt35r kit i going to weld both vband flanges together |
odd.. i was just thinking of cutting off my dp's 3 bolt flange and rewelding my v-band back on..
|
Read it all, but especially see post #14 of this thread: https://www.rx7club.com/showthread.p...hlight=gaskets
|
Usually it is just a tightening issue as dubulup stated. It can matter in which sequence you tighten it in. I haven't had any here that I couldn't get ot stop leaking just by going over the exhaust a few times. Sometimes you may need to loosen the turbine housing on the manifold, tighten the turbine to Dp then tighten the housing to the manifold. If for some reason it is beat up a bit. It is a low pressure area. You can use some high temp sealer between the faces then clamp. It won't blow out. It is used to just "fill in" the imperfections so both surfaces mate up.
-S- |
All times are GMT -5. The time now is 02:51 PM. |
© 2024 MH Sub I, LLC dba Internet Brands