Omp lines and AN size
Hey guys
Does anybody know the size of the hole of the banjo fitting on the oil injectors?? 8mm 10mm???? Also what size AN fitting do I need for the oil feed lines from the top front iron and for the oil cooler lines Am thinking of going -10AN for the oil cooler and turbo feed and drain lines And info would help Thanks jc |
Anybody??
|
10mm banjo for oil injectors. I normally do them -3 .
|
-10AN is too large for the turbo oil feed. Its ok for the drain though.
I think you need a -4AN or -6AN oil feed and an appropriate oil restrictor for the turbo your running. |
I used -6 for the turbo suppily, -10 for the oil coolers.
|
Ok thanks guys
So turbo supply should be -6an And return -10 got it.. Thanks But what's the size of the hole on the iron 18mm?? |
Originally Posted by rx72c
(Post 11843711)
10mm banjo for oil injectors. I normally do them -3 .
And what do you mean -3?? How?? Thanks jc |
As in Dash 3 Hose.
Ill get back to you about the thread on the oil metering pump. |
Originally Posted by rx72c
(Post 11843761)
As in Dash 3 Hose.
Ill get back to you about the thread on the oil metering pump. |
All times are GMT -5. The time now is 11:01 PM. |
© 2024 MH Sub I, LLC dba Internet Brands