How to do a AN braided Oil Drain line?
I've got a S5 Turbo and a S4 front cover and I only have S5 Oil drain lines so they don't work.
I'm thinking of fabbing AN lines. Will this work on the stock S5 turbo? http://www.atpturbo.com/Merchant2/me...egory_Code=FLA Then is it about a foot of -10AN or a different size? I don't have an adapter plate for the front cover. Any thoughts? I was hoping I could cut it about an inch from the mouting point and tap some threads into it. Then scrwe in the other side of the AN line. Also I am totally not familiar with AN stuff. Do you have to get the hose precut or can you cut it? Then how do you get the metal connector pieces on? Thx. |
Will that T3/4 flange thing work on my front cover as well? They seem to be the same size.
Thx |
I dunno about your FC stuff but on my FD i used that same adapter to my ~12 fitting with a male end, then to my 6-8" braided SS line with a straight female hose end going up and a 45 going to the block. On the block i have the stock oil return with a ~12 welded onto it with the other side connected to that. I'm not sure how much that helps you out but you miht get somewhere.
|
OK I'm still doing this.
I bought 2 ft of SS line. and the connectors with a plug which is 8AN to 3/8th's Do you think this will work. It says it's for T3/T4's. http://www.atpturbo.com/Merchant2/me...egory_Code=FLA If it connects to my turbo then it should work on my front cover since they are the same size. It says it is a 1/2 NPT size. I'm running 3/8th and I think 8AN so I shoudl probably get a reducer. Any thoughts? |
What connection are you using that uses the 3/8ths/-8, i would guess that was kinda small, i used a -8 before my -12 and i saw alot of smoke before the change. Also what size connecters did you buy if it is -8 i would suggest going with a larger hose, due to teh fact that the return is under very little presure it needs to be larger enough that it doesnt back up. I would go with a -10 or 12 if i were you.
|
well i got those T3/4 flanges. They are 1/2 inch threaded.
I also started to think about that sizing. I am going to the performance store again Friday to get a 90` bend and I think I will upgrade the AN hose to -10 and get some 1/2inch to -10an adapters. |
i would suggest a 45' bend, i would think the less of the angle the better drain it ould allow
|
All times are GMT -5. The time now is 06:43 AM. |
© 2024 MH Sub I, LLC dba Internet Brands