Harness help
Hi have a 93 fd
It was an automatic and I did the full swap And now I'm rewiring the harness. Also did a single turbo swap. This is what I installed.. As far as harnesses -93 firewall harness -93 dash harness -93 single turbo harness (emissions gone) I looked up all the connector and wires pin by pin that are coming from the front engine harness on a (93 base manual Schismatic..) And All the wires and connector are on the same location on the drivers side Automatic harness.. Like I said I went pin by pin and wire by wire. I also made some videos and took some pictures.. I can confirm that the front engine harness on a automatic is the same from the most parts... If you need to videos contact me. Now on the passenger side the same go's (BUT) with a few exceptions On the (((x-07 male connector there's a (y)= yellow wire that's missing))) And the ( x-05 blue connector---is different you guys already know that ) it has more wires and the connector is bigger then the manual one.. I'm trying to follow this auto to manual wire up https://www.rx7club.com/3rd-generation-specific-1993-2002-16/auto-manual-harness-conversion-222574/ But my (x-05 blue connector) this is the male one from the manual single turbo engine harness is missing 2 wires B/L= black and blue- magnetic clutch a/p B/G= black green- a/p magnetic clutch So here's my question do I need those two wires?? Here are the connectors that are the same Driver side X-04 ✅. X-06 ✅ Jb-14 ✅ Jb-06 ✅ X-08 ✅ X-10 ✅ J4-04 ✅ F1-01 ✅ Passenger side X-13✅ X-14✅ Remember that I swapped out my dash and firewall harness so the x-07 (female) firewall harness checks out ✅ And my x-14 dash (female) and x-14 (male) single turbo engine harness both checked out ✅ The yellow ( B1-01 passenger side Ecu (2) connectors) I mite need to move 1 or 2 wires but everything was in its place For the most parts |
All times are GMT -5. The time now is 03:16 PM. |
© 2024 MH Sub I, LLC dba Internet Brands