RX7Club.com - Mazda RX7 Forum

RX7Club.com - Mazda RX7 Forum (https://www.rx7club.com/)
-   Single Turbo RX-7's (https://www.rx7club.com/single-turbo-rx-7s-23/)
-   -   400 whp @ 12 psi with stock engine. What do I need? (https://www.rx7club.com/single-turbo-rx-7s-23/400-whp-%40-12-psi-stock-engine-what-do-i-need-40247/)

wentpearshaped 12-20-01 10:41 PM

400 whp @ 12 psi with stock engine. What do I need?
 
Could someone tell me what turbo I need to run 400 whp with only 12 psi boost on a stock engine? Is it possible?

Thanks.

Gene

JoeD 12-20-01 11:39 PM

Re: 400 whp @ 12 psi with stock engine. What do I need?
 

Originally posted by wentpearshaped
400 whp @ 12 psi with stock engine. What do I need?
a miracle. :)

RecKleSs 12-21-01 12:03 AM

I seriously don't think that is possible. I think Ernie T pulled around 380 RWHP @12psi and that is with a street ported engine. Also, 12psi is really not a lot of boost for a single turbo.

wentpearshaped 12-21-01 12:12 AM

Yes, I wanted to keep the boost low as possible since I want to road race the car. Do you know what turbo setup Ernie T has?

shinjuku 12-21-01 12:22 AM

Goto the australian forum (on this site) and you'll see streeter selling his setup for $1500 (that's oz dollars). This setup got over 350rwhp out of a stock 13Bt (except obviously extra injectors etc)...

Manolis_D 12-21-01 05:22 AM

How about a T04 62-1?
 
I think (although I could well be wrong ;) ) that you could probably make about 350 rwhp with a T04 62-1 P trim compressor and maybe a 1.15 A/R housing at 10-12lbs of boost, but that would probably have quite a bit of lag.
Nitrous :D

Good luck!,
Manolis

wankawankel 12-21-01 08:09 AM

12psi on a stock engine? Add 150 shot, and maybe you'll get that HP.

Roy Johnson, Jr 12-21-01 10:01 AM


Could someone tell me what turbo I need to run 400 whp with only 12 psi boost on a stock engine? Is it possible?
Not gonna happen.



Yes, I wanted to keep the boost low as possible since I want to road race the car...
If you're wanting to keep the boost low, you need to have a setup where you are able to realize the the efficiency range of your turbo(s).

If road race means track racing, I would recommend the sequential setup with the mods listed below.

If road race means street racing, I would say a small single.

I would recommend these modifications: intake, full exhaust, pulleys, BOV, Greddy elbow, intercooler, upgraded clutch, lightened flywheel, upgraded fuel pump and regulator, upgraded ignition, upgraded radiator, computer and 1200cc secondaries. I think I got everything :)

Either way you go, you are going to have to run 16-17 psi for 400 rwhp. Without NOS assistance, less boost than this will be less HP.

With this on sequential setup and proper tuning, you should be able to see 350-375 rwhp.

With this setup on a small single, you should be able to see upwards to 400 rwhp.

Hope this helps.


All times are GMT -5. The time now is 09:59 PM.


© 2024 MH Sub I, LLC dba Internet Brands