Turbo 2 tranny on an fd motor
Does it fit? Do I need to replace the bellhousing with another one? what about the clutch and pressure plate do i need to use turbo 2 or still can use the third gen one? Im going from old school bridge ported 12a to 13b turbo alcohol .......any help would be apreciated.
|
works perfect if using the TII clutch/pressure plate and TII starter :)
|
^^^ what he said ... running a REW in my FC too
|
thanks for the answer fellas!!! So I will not be able to use the fd pressureplate or clutch? Its freaking new.... Do I need to buy a turbo 2 clutch set? Im freaking swaping from bridged 12a NOS with turbo 2 and rx4 bellhousing to fd turbo alcohol on my starlet.
|
Wont work unless you buy a conversion kit for the throw out bearing. FD is push/pull type (or other way around). Youtube how an FD clutch works
|
Originally Posted by jaggermouth
(Post 10705764)
Wont work unless you buy a conversion kit for the throw out bearing. FD is push/pull type (or other way around). Youtube how an FD clutch works
|
T2 tranny fits on fd engine, You will need to grind the rear iron a bit if using a stock t2 flywheel.
|
^I found that out at the last minute. You have to do a small cut on the rear edge of the plate on the exhaust side or the flywheel will catch the lip.
|
TII clutch bolts right to the FD flywheel using a TII slave, TII throw out bearing. pilot bearing is the same spline pattern as well.
|
ok ordered turbo 2 stage 4 clutch kit. Can I keep the fd fly wheel and starter?
|
Not sure about the starter but I'm using the stock FD flywheel.
|
All times are GMT -5. The time now is 08:46 AM. |
© 2024 MH Sub I, LLC dba Internet Brands