LIGHTS OUT IV in VALDOSTA GEORGIA
 

any body going, am in, just talked to the promoter, we can run clutchless tranny
am getting ready
more info at http://www.duckxxx.com/

MACFAB BEADLOCKS
OUTLAW 275
OUTLAW 275 VS 28-10.5



(NO MINIMUM CAR COUNT REQUIRED)

OUTLAW 275 VS 28-10.5 AND OUTLAW X RULES WILL BE THE SAME SO YOU CAN RUN NORTH OR SOUTH EVENTS


TECH CARD 200.00
(32 CAR QUALIFIED FIELD)

Weights

n/a SB 2400lbs

n/a BB short deck conventional head 2800lbs

n/a BB tall deck conventional head 2900lbs

n/a BB short deck big chief 2900lbs

n/a BB 10.2 tall deck big chief 3000lbs

28 X 10.5 nonW slick or 275 drag radial

Nitrous Small Block: 2450 lbs

Nitrous Big Block 4.840(10.2 deck okay,: 3000 lbs add 100 lbs for Big Chief
-75LBS FOR SINGLE CAST MANIFOLD BB

Base weight 5.00 & up 3200

Big Chief combos max 3 kits

supercharged (SB only)- 2800lbs base weight with F1C or Ysi

add 100lbs for F1R/Xi or

add 100lbs for Z trim

add 250lbs for F2R

add 300lbs for F3R - 123mm max inlet

add 250lbs for F1X
- 50lbs for inline head

deduct 50 lbs for non intercooled

gear drive okay

28 X 10.5 nonW slick or 275 drag radial

single turbo (SB only)- 2800lbs base weight with 80 mm

add 100lbs for bigger than 80 mm

add 150 lbs for 85 mm

add 200lbs for 88 mm

add 250lbs for 94 mm

add 300lbs for 98 mm

single turbo (sb only) 3050 lbs base weight for any (101 or bigger that is being reduced )

add 100lbs for bigger than 80 mm

add 150 lbs for 85 mm

add 150lbs for 88 mm

add 175lbs for 94 mm

add 200lbs for 98 mm

- 50lbs for inline head

deduct 50lbs for non intercooled

no weight break for tip to tip single turbo entry

28 X 10.5 nonW slick or 275 drag radial

twin turbo's (SB only)- 3250lbs base weight max 67 mm.

reducer sleeve must be within .250 of leading edge of turbo compressor inducer on twin application only

-50 lbs for any tip to tip non reduced entry (twin turbo entry)

add 50 lbs 70 mm

add 100lbs 76 mm

add 150 lbs 80 mm

28 X 10.5 nonW slick or 275 drag radial

Leaf springs - 100#

No wheelie bars

Mufflers required on non turbo charged entries

Progressives okay

7531 okay

Lexan okay

Fiberglass okay

Alcohol –Ok

Auto Trans or Factory clutch type manual (clutch assisted okay)

REDUCERS -OK
NO DUAL POWER ADDERS

- 100# for any modular engine entry

I didnt see any rotary info there?

Any uptades on this.