80 psi presssure regulator
Does anyone have any experience with an 80 psi oil pressure regulator on a street car? Anything negative to say about them?
|
It should be fine. Maybe slightly higher oil consumption.
|
I used one on my bridgeport, now its on the turbo streetport engine, no apparrent problems, probably safer for me to rev past 7000rpm. Remember 10psi oil pressure for every 1000rpm is required for engines.
|
Hey Matt, I've done about 4 or 5 of these on some of the newer, more recent engine jobs. It seems to work well. However, I'm looking more into the 100+psi units as I want to run 9000rpm's. I'm looking to use the FD regulator but am not sure if shimming the oil pressure control valve is necessary or not.
B |
I went ahead and ordered one from Racing Beat, thanks for the opinions guys.
|
I just banged on my existing oil pressure regulator with a hammer and shimmed oil pressure control valve...now my oil pressure is about 90-95 psi on a high side and doesn't go below 60psi. I think that's not too bad concidering i didn't spend any money on the mod.
|
12a how did you do shim the valve? And why did you bang on the pressure regulator?
|
You put a washer under the spring in the front and rear regulator. 12A, you didnt just hammer the end to make the hole smaller did you? Why not disassemble it and shim it?
|
I think this only works with pre-FC engines.  When going with the FC's, Mazda made the OPR's tamperproof. :(
If anyone has a mod to modify the stock FC units, I'm all ears! -Ted |
Originally posted by RETed I think this only works with pre-FC engines.  When going with the FC's, Mazda made the OPR's tamperproof. :( If anyone has a mod to modify the stock FC units, I'm all ears! -Ted B |
Wouldn't be a bad idea but on a street car their isn't much to gain. It'll cause excess oil foaming on E-shaft which may not be good.
|
OPR
Originally posted by RETed I think this only works with pre-FC engines.  When going with the FC's, Mazda made the OPR's tamperproof. :( If anyone has a mod to modify the stock FC units, I'm all ears! -Ted |
P.S. reinsert the pin back and JB Kwiked it.
|
Another word of wisdom for the Ho Master!
-Ted |
All times are GMT -5. The time now is 08:21 AM. |
© 2024 MH Sub I, LLC dba Internet Brands