Do any of you veteran racers use splitters on the front or rear? Where can I find a set?

Any other aero advice would be appreciated?

 

I've never heard of, nor read of a rear splitter.

 

maybe he means a rear diffuser.

 

I know I've read about a few ITS RX7's using splitters on the front. The ones I've seen I think are called ISC splitters. They are usually on the very high end ITS cars that I've read about.

 

On the front they are splitters, the rear is diffuser's. I'll try to find a pic

 

http://www.machevo.com/cafifrsp.html

Here's one on an evo

 

On the bumper and lower lip

 

Damon has a front splitter, pm him

 

There is a tech article about the effectiveness of spliters at the bottom of the race section you should check out. ISC builds splitters only for FC's as far as I know. My It-s car will be getting a home made splitter soon, as they arent very complicated to build. most "high end" Its race splitter are just simple molded fiberglass, or a plywood board attached by some spacers.

 

rear diffusers are a whole other story. I dont know anyone using one functionally

 

most of the race cars iv'e seen use a piece of 3/8" plywood, painted black. wood is light, stiff, and cheap. the ricers will laugh at it, but anything that hangs that low is going to be ruined, and the air doesnt care what it's passing over.

 

Flatout Motorsports has one listed in their catalog on their site:
http://www.flatout-motorsports.com/c...b234aff6467c6a

Big money....don't even know if it is still available.

 

i will be selling my undertray/splitter shortly...here are some pics:



http://www.myrx7.com/images/underpanel_taklam_1.jpg

http://www.myrx7.com/images/underpanel_on.jpg

http://www.myrx7.com/images/underpanel_after_4.jpg


the thread on it is here:
https://www.rx7club.com/forum/showth...light=splitter