FC 2.3T Hood Clearance Fix?
So who has photos of what they did to make the ford 2.3T fit in the FC. Any confirmation that a TII style scoop will cover up what must be cut out?
I am looking at doing this swap but I want to know exactly what hood fix is needed before I undertake the purchases. I am aware a bulge is needed, I want to see pics though. I want to keep this looking as stock as possible as I do not want a huge cowl hood. Thanks, |
I'm getting close to getting the engine in my 88 vert. I'll let you know what it looks like when the time comes. At this point it looks like I will need approximately 2 inches of clearance both at the cam sprocket and at the point which the turbo goes over the valve cover. I had to raise the engine a good 1/2 to 3/4 inch to clear the power steering rack, but everything else has fit nicely. If I would have rotated the upper intake I probably could have saved clearance over the valve cover, but I don't mind a small cowl. At any rate, I'll try to let you know. Let me know how your project is going.
|
Well when I spoke with Grannys I mentioned to them about using the TII hood scoop and cutting it out then welding it centered up on a regular alum. hood. Either that or they said I could lower the whole subframe with some shims, but to me I would rather put a scoop on the hood.
I have also read rumors of being able to notch the hood support and the motor will clear just fine. So really, I am at a loss I guess until I actually do it myself. |
All times are GMT -5. The time now is 01:39 AM. |
© 2024 MH Sub I, LLC dba Internet Brands