Removing bus bar from coils?
In my attempt to hide almost all my wires, I want to now remove this bus bar from on top the coils. I am just unsure on how to do this...
Ant help on which wire goes where? http://i282.photobucket.com/albums/k...ps8f466228.jpg http://i282.photobucket.com/albums/k...psbd8dbfc4.jpg |
Both coils should have 12v when the key is on ON position. Disconnect that thick red wire and connect it directly to the white wire and ditch the black wire to that white box/resistor
|
thats not a bus bar its a ballast resistor , if you want to remove it you need to buy coils that have internal ballast resistors
|
Coils from and 81 thru 85 12A RX-7 would work to do this.
Originally Posted by mattallac
(Post 11740792)
thats not a bus bar its a ballast resistor , if you want to remove it you need to buy coils that have internal ballast resistors
|
to rid this properly you need to upgrade to the electronic dizzy and coils that no -longer require the ballast resister ( drops coils to about 9 V )
points ignition with the 12v coils is going to burn the points up rapidly and running the 9v coils at 12v will have similar results but also risks the coils exploding during idle or when key left in the ignition |
I am using the 85 distributor. I have 2 msd blaster coils that I am going to swap these for.
|
All times are GMT -5. The time now is 03:18 PM. |
© 2024 MH Sub I, LLC dba Internet Brands