datsun rotary?
 

Do many people put rotary's in datsun 240z's or 510's? i found this site:

http://www.bryanf.com/510/index.htm

so do people put a 13b for example in a 240z?

Wow, very interesting draw through setup

i have one in my datsun 520

putting a rotary in a 510 is not an original thing. there are a few out there, but many are not well documented. there are even a few threads on the board about them. since they are a hybrid of sorts, they usually will bounce between the 510 and rotary online communities like i do.

as you can tell from my sn, i dropped a rotary into my 510.
bryanf's rotary 510 is probably the standard by which most will measure up to for a while. while ultra impressive, i dont have the fabrication skill nor patience to wait that long to drive my car.

I've seen several early 240's race with 13b-rew's

i almost had a 13b TII 510 wagon but sold my project and bought a 2 door. the post is on here.

http://forums.hybridz.org/showthread...&highlight=13B

he used a 13B-RE

back in the 1980's we did (me and my dad) a full tube 510 with a PP 13B cut and set back 8 inches into the fire wall.............
that car ran so good they banned us.............then we went rx7...LOL
but that car was wild.all fiber glass weighed just about 1300-1500 lbs
with a pickup rear end and diff ..i think it was about a 4:7 rear.......
set was a breeze...just use front cover from a older engine and make a bracket


then gear box bracket and drive like crazy...OK ok ok not sooo simple but close enough

I get to start working on getting a 4 port 13B with a 5" Camden SC in a 510 tomorrow. I'll work on it over the next few weeks.

bryanf's rotary 510
 

OMG... can't believe the level of Uber-detail. I'm jealous as hell of the skill and thought put into the final product. Very VERY impressive. Definitely the new bar!

Ok so I got the motor and trany in the 510 and mocked up the motor mounts, this weekend I'll see how much I can push the motor back. Maybe I'll take a few photos shit and gigles :)

OK here's a few photo's for shit and gigles, not gonna be as pretty as bryan's 510 but I'll make do with what tools I have available after all I'm no expert. Next weekend I'll make the trany mount and weld the motor mounts in place.:)

Saw this 510 this morning, very creative. So get that shit done already. I need you to finish the manifold for my TII Bridgeport blow thru RX-3. :)

Bring the car in two weeks, I just need to finish the mounts so I can take the car off the stand.... I'll make room for you:)

nice...and good job on stuffing the motor back as far back as possible...

The old 13B is almost ready to pull from the 510. The SC engine just needs a clutch disc and it will be ready to go in.